Cub Cadet SC2400 manual First 50 Hours, Every 50 Hours, Periodic Service, IMPORTANT: Avoid damage

14. PERIODIC SERVICE

3.First 50 Hours

■Changing the Engine Oil

For the maintenance work, see “Engine Oil” on page 14-23.

■Replacing the Engine Oil Filter

For the maintenance work, see “Replacing the Engine Oil Filter” on page 14-27.

■Changing the Transmission Oil

For the maintenance work, see “Changing the Transmission Oil and Replacing the Transmission Oil Filter” on page 14-29.

■Replacing the Transmission Oil Filter

For the maintenance work, see “Changing the Transmission Oil and Replacing the Transmission Oil Filter” on page 14-29.

4.Every 50 Hours

■Checking the Front Axle Oil Level

IMPORTANT: Avoid damage.

●Before checking the oil level, allow the oil to settle for 1 hour so that the current oil level can be accurately read on the dipstick. Recheck the oil level after operating the tractor for several hours.

1.Park the tractor safely and securely.

2.Allow the tractor to cool off for at least 1 hour and the oil to settle.

IMPORTANT: Avoid damage.

●Dirt and debris in the oil may damage the front axle. Clean the area around the dipstick before removing it.

3.Loosen and remove the dipstick situated on the right side of the front axle.

4.Wipe the dipstick clean with a rag. Only insert the dipstick into the hole on axle. At this point, do not fasten the dipstick into the axle case.

5.Remove the dipstick again. Read the oil level on the dipstick. The oil level should be between the high and low level marks on the dipstick.

When the oil level is low:

•Add Cub Cadet GEAR LUBE or SAE 80W-90 gear oil through the fill opening until the oil level is appropriate.

•Reinstall and tighten the dipstick.

6.Operate the tractor for several hours, and then check the front axle oil level again.

(A)Dipstick

(A)

P3014922

(A)

High

Low

3013741

3014928

Sc2400 Operator’s Manual 14-18