D-Link DCS-900 manual Connections, Network Cable Connector, DC Power Connector, Reset Button

Connections

Rear Panel view

Ethernet Cable

Connector

DC Power Connector

Reset Button

Network Cable Connector

The DCS-900 features an RJ-45 connector for connections to 10Base-T Ethernet cabling or 100Base-TX Fast Ethernet cabling (which should be Category 5 UTP twisted-pair cable). The port supports the NWay protocol, allowing the DCS-900 to automatically detect or negotiate the transmission speed of the network.

DC Power Connector

The DC power input connector is labeled DC 5V with a single jack socket to supply power to the DCS-900.

Reset Button

Reset will be initiated when the reset button is pressed once and Power LED begins to flash.

Factory Reset will be initiated when the reset button is pressed continuously for three seconds or when the Power LED begins to light up. Release the reset button and the Power LED will begin to flash indicating that the DCS-900’s settings are reverting back to the factory settings. The IP address will also return to the default setting of 192.168.0.20.

6