w w w . d e l l . c o m s u p p o r t . d e l l . c o m

10Press <Esc> to exit the Advanced Menu. You are prompted to accept the settings.

11Highlight Accept and press <Enter>. Do not initialize the logical drive.

12Press <Esc>. and choose Yes at the Save prompt.

13Exit the BIOS Configuration Utility.

14Reboot the system.

15Set the host system to boot from SCSI, if such a setting is available.

Exiting the PERC 3 BIOS

Configuration Utility

Perform the following steps to exit the BIOS Configuration Utility.

1Press <Esc> when the Management Menu displays.

2Choose Yes at the prompt.

3Reboot the computer.

The PERC 3 BIOS message appears again.

4Press <Esc> when the BIOS Configuration Utility prompt appears.

Setting Hardware Termination

If you are using the PERC 3/DC for clustering, you must use hardware termination. Otherwise, software termination may be used. The headers used for SCSI termination are:

J2 Termination Enable is a three-pin header that specifies control of the SCSI termination for channel 0.

J3 Termination Enable is a three-pin header that specifies control of the SCSI termination for channel 1.

J5 Termination Enable is a three-pin header that specifies control of the SCSI termination for channel 2.

J7 Termination Enable is a three-pin header that specifies control of the SCSI termination for channel 3.

184

PERC 3 BIOS Configuration Utility

Page 186
Image 186
Dell manual Exiting the Perc 3 Bios Configuration Utility, Setting Hardware Termination