w w w . d e l l . c o m s u p p o r t . d e l l . c o m

6Connect the SCSI cables to SCSI devices.

Make sure all cables are properly attached, and that the PERC 3/SC card is properly installed.

7Set the target IDs for the SCSI devices.

8Replace the computer cover and turn the power on.

Be sure the SCSI devices are powered up before or at the same time as the host computer.

9Run the PERC 3 BIOS Configuration Utility or WebBIOS Configuration Utility to configure arrays and logical drives.

10Install software drivers for the desired operating systems.

Step 1—Unpack

Unpack and install the hardware in a static-free environment. The PERC 3 is packed inside an anti-static bag between two sponge sheets. Remove the controller card and inspect it for damage. If the card appears damaged, or if any item listed below is missing, contact your Dell support representative.

The PERC 3 controller also comes with:

The PERC 3 User’s Guide

A license agreement

The PERC 3 configuration utilities diskette

Step 2—Power Down

Turn off the computer and remove the cover. Make sure the computer is disconnected from any networks before you install the controller card.

104

PERC 3/SC Hardware Installation

Page 106
Image 106
Dell manual Unpack, Power Down, License agreement Perc 3 configuration utilities diskette, 104