Table
Message | Causes | Corrective Actions |
|
|
|
Attempting to update | Remote Configuration is in | Wait until the process is complete. |
Remote Configuration. | progress. |
|
Please wait.... |
|
|
|
|
|
BIOS Update Attempt | BIOS remote update failed. | Retry update. |
Failed |
|
|
|
|
|
Caution! NVRAM_CLR jumper | NVRAM_CLR jumper is installed. | Remove the NVRAM_CLR jumper. |
is installed on system |
| |
board. |
| page 115 for the jumper location. |
|
|
|
Data error | Faulty diskette, diskette drive, | Replace the diskette. Ensure that the |
| optical drive, hard drive. | diskette drive, optical drive, and hard- |
|
| drive cables are properly connected. |
|
| |
|
| |
|
| |
|
| page 102 for the appropriate drive(s) |
|
| installed in your system. |
|
|
|
Decreasing available | Faulty or improperly installed | Ensure that all memory modules are |
memory | memory modules. | properly installed. See |
|
| |
|
| |
|
|
|
Diskette drive 0 seek | Incorrect configuration settings in | Run the System Setup program to |
failure | System Setup program. | correct the settings. See "Using the |
|
|
Faulty or improperly installed diskette, loose diskette drive or optical drive interface cable, or loose power cable.
Replace the diskette. Ensure that the diskette drive and optical drive cables are properly connected. See ""Troubleshooting a Diskette Drive" on page 101" and ""Troubleshooting an Optical Drive" on page 102" in "Troubleshooting Your System."
Diskette read failure | Faulty or improperly inserted | Replace the diskette. |
| diskette. |
|
Diskette subsystem reset | Faulty diskette drive or optical drive |
failed | controller. |
Ensure that the diskette drive and optical drive cables are properly connected. See "Troubleshooting a Diskette Drive" on page 101 and "Troubleshooting an Optical Drive" on page 102. If the problem persists, see "Getting Help" on page 121.
About Your System |
| 19 |
|