Dell 840 manual Error encountered in initializing, PCI device faulty system board, Your system

Table 1-6. System Messages (continued)

Message	Causes	Corrective Actions
Plug & Play Configuration	Error encountered in initializing	Install the NVRAM_CLR jumper and
Error	PCI device; faulty system board.	reboot the system. See Figure 6-1 for
		jumper location. Check for a BIOS
		update. If the problem persists, see
		"Troubleshooting Expansion Cards"
		on page 108. If the problem persists,
		see "Getting Help" on page 121.
Primary drive n	Faulty hard-disk drive.	Replace the hard-disk drive. See
configuration error		"Troubleshooting SATA Hard Drives"
Primary drive 1 failure		on page 105 or "Troubleshooting a
		SAS RAID Controller" on page 107 in
		for the appropriate drive(s) installed
		in your system.
Read fault	Faulty diskette, diskette drive,	Replace the diskette. Ensure that the
Requested sector not	optical drive, or hard drive.	diskette, optical, and hard-drive cables
found		are properly connected. See
		"Troubleshooting a Diskette Drive" on
		page 101, "Troubleshooting an Optical
		Drive" on page 102, "Troubleshooting
		SATA Hard Drives" on page 105," or
		"Troubleshooting a SAS RAID
		Controller" on page 107" for the
		appropriate drive(s) installed in your
		system.
Remote Configuration	System could not implement	Retry Remote Configuration.
update attempt failed	Remote Configuration request.
ROM bad checksum =	Faulty or improperly installed	Remove and reseat the expansion
address	expansion card.	cards. See "Troubleshooting
		Expansion Cards" on page 108.

SATA	Port	n	hard disk	Faulty SATA hard drive.
drive configuration error
SATA	Port	n	hard disk
drive failure

SATA Port n hard disk drive auto-sensing error

Replace the hard-disk drive. See "Troubleshooting SATA Hard Drives" on page 105 for the appropriate drive(s) installed in your system.

About Your System

23