2Install the hard drive in the hard-drive bay:

a Slide the drive into the drive bay with the back of the drive toward the back of the drive bay. b Install the screws that secure the drive in the drive bay.

3Install the hard-drive bay. (See Figure 3-8.):

a Slide the drive bay into the system until the drive bay contacts the system. b Install the three screws that secure the drive bay in the system.

NOTICE: To prevent damage to internal system components, ensure that a connector cap is installed on each available power connector that is not connected to a hard drive.

4Connect a power cable to each hard drive. (See Figure 3-8.)5Connect the hard-drive interface cables to each hard drive.

–If you are installing a SATA hard drive, connect the SATA interface cable to the hard drives and to the SATA ports on the system board. (See Figure 3-9.)

–If you are installing a SAS drive, connect the SAS interface cable to the hard drives and to the optional SAS controller card. (See Figure 3-10.)

56Installing System Components