9Run the SAS controllers tests and the
If the hard drive fails the
Hot-Plug SATA Hard Drives Using the SAS Backplane
If you are using the optional SAS backplane, the SATA hard drives you install are
The SAS backplane supports up to four
Removing and Installing the Optional SAS Backplane Board
The optional SAS backplane board supports
CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. Before performing any procedure, see your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge.
1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2Open the system. See "Opening the System" on page 43.
3Remove all existing hard drives from the hard drive bay. See "Removing a Hard Drive from the Drive Bay" on page 54.
4Install the SAS backplane:
a Lower the backplane into the system and align the backplane with the retention hooks on the drive bay, then fit the backplane over the retention hooks.
b Slide the backplane board toward the front fan about 12 mm (0.5 inch) until it clicks into place.
Installing System Components |
| 61 |
|