Table
Message | Causes | Corrective Actions |
|
|
|
Keyboard data line | Loose or improperly connected | Ensure that the keyboard is properly |
failure | keyboard cable; faulty keyboard; | connected. If the problem persists, |
Keyboard failure | faulty keyboard controller. | replace the keyboard. If the problem |
| persists, see "Getting Help" on | |
Keyboard stuck key |
| |
| ||
failure |
| |
|
| |
|
| |
Keyboard fuse has failed. Keyboard fuse has failed. | Replace the keyboard. | |
|
|
|
Manufacturing mode | System is incorrectly configured. | Install the NVRAM_CLR jumper and |
detected |
| reboot the system. See "System Board |
|
| Jumpers" on page 115 for jumper |
|
| location. |
|
|
|
Memory address line | Faulty or improperly installed | Ensure that all memory modules are |
failure at address, read | memory modules, or faulty system | properly installed. See |
value expecting value | board. | |
Memory double word logic |
| page 100. If the problem persists, see |
| ||
failure at address, read |
| |
|
| |
value expecting value |
|
|
Memory odd/even logic |
|
|
failure at address, read |
|
|
value expecting value |
|
|
Memory write/read failure |
|
|
at address, read value |
|
|
expecting value |
|
|
|
|
|
Memory tests terminated | The spacebar was pressed during | Information only. |
by keystroke | POST to terminate the memory |
|
| test. |
|
|
|
|
More than one RAC |
| Verify that the RAC is installed in the |
detected, system halted |
| proper PCI expansion slot (SLOT_5). |
|
| If a RAC is installed in any other slot, |
|
| remove it. |
About Your System |
| 21 |
|