Dell M2010, PP03X owner manual 131, Securing clips 2 per

2

1

1 securing clips (2 per	2	memory module
connector)

NOTICE: Insert memory modules at a 45-degree angle to avoid damaging the connector.

NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

5Ground yourself and install the new memory module:

a Align the notch in the module edge connector with the tab in the connector slot.

b Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove the module and reinstall it.

6Replace the memory cover by aligning the notches in the cover with the tabs on the base and sliding the cover toward the front of the computer, then tighten the screw.

NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.

7Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.

8Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

To confirm the amount of memory installed in the computer, click the Start button, click Help and Support, and then click Computer Information.

Adding and Replacing Parts

131