1

2

3

4

5

card door

captive screw on card door

card connector

card

card screw

Coin-Cell Battery

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

1.Follow the procedures in "Before You Begin."

2.Turn the computer over, loosen the two captive screws on the memory module/coin-cell battery cover, and then remove the cover.

NOTICE: To avoid damaging the system board, ensure that you do not remove the plastic film between the battery and the system board as you move the double-sided tape to the replacement coin-cell battery.

3.Gently pull the coin-cell battery from the system board, and disconnect the cable connector from the system board.

4.Remove the double-sided tape from the coin-cell battery.

Page 74
Image 74
Dell PP06S, D410 specifications Coin-Cell Battery