Dell XPS 420 owner manual 113

book.book Page 113 Tuesday, November 27, 2007 10:29 AM

1

2

1 card retention door 2 release tabs (2)

10Close the card retention door by snapping it into place to secure the card(s).

NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment.

11Connect any cables that should be attached to the card.

See the documentation for the card for information about the card cable connections.

NOTICE: To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.

12If you replaced a card that was already installed in the computer and you removed the retention mechanism, reinstall the retention mechanism.

13Before replacing the card retention mechanism, ensure that:

•The tops of all cards and filler brackets are flush with the alignment bar.

•The notch in the top of the card or filler bracket fits around the alignment guide.

14Snap the card retention mechanism into place, securing the PCI card.

Removing and Installing Parts

113