Dell XPS 420 owner manual Removing Memory

book.book Page 108 Tuesday, November 27, 2007 10:29 AM

6Insert the module into the connector until the module snaps into position.

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.

7Replace the computer cover.

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

8Connect your computer and devices to electrical outlets, and then turn them on.

9Right-click the My Computer icon, then click Properties.

10Click the General tab.

11To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Removing Memory

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. You can do so by touching an unpainted metal surface on the computer.

1Follow the procedures in "Before You Begin" on page 99.

2Remove the computer cover (see "Removing the Computer Cover" on page 101).

108

Removing and Installing Parts