Dell XPS 600 owner manual Clearing Forgotten Passwords, 137

4At the bottom of the menu, enter the number of the device that is to be used for the current boot only.

For example, if you are booting to a USB memory key, highlight USB Flash Device and press <Enter>.

NOTE: To boot to a USB device, the device must be bootable. To make sure that your device is bootable, check the device documentation.

Changing Boot Sequence for Future Boots

1Enter system setup (see "Entering System Setup" on page 131).

2Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the menu.

NOTE: Write down your current boot sequence in case you want to restore it.

3Press the up- and down-arrow keys to move through the list of devices.

4Press the spacebar to enable or disable a device (enabled devices have a checkmark).

5Press plus (+) or minus (–) to move a selected device up or down the list.

Clearing Forgotten Passwords

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

1Follow the procedures in "Before You Begin" on page 69.

2Locate the 3-pin password jumper (PASSWORD) on the system board (see "System Board Components" on page 78), and attach the jumper plug to pins 2 and 3 to clear the password.

NOTE: When you receive your computer, the jumper plug is attached to pins 1 and 2.

3Close the computer cover.

4Connect your computer and monitor to electrical outlets, and turn them on.

Appendix

137