Denon AVR-1611 Error messages, Parameter Check, NOTE, ENTER, ENGLISH, Examples, Measures, Error details, 3 Press RETURN, Retrieving Audyssey Auto Setup settings

ENGLISH

Error messages

An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.

NOTE

Be sure to turn off the power before checking speaker connections.

	Examples		Error details	Measures
Caution			• The connected setup microphone is broken, or a	• Connect the included setup microphone to the
		MultEQ	device other than the supplied setup microphone	SETUP MIC jack of this unit.
	FMicrophone:None		is connected.
	or
			• Not all speakers could be detected.
	Speaker	:None
			• The front L speaker was not properly detected.	• Check the speaker connections.
	Retry
	Cancel
[ENT]:Retry
Caution			• There is too much noise in the room for accurate	• Either turn off any device generating noise or
		MultEQ	measurements to be made.	move it away.
	FAmbient noise is			• Perform again when the surroundings are quieter.
	too high or
			• Speaker or subwoofer sound is too low for	• Check the speaker installation and the direction
	Level is too low.
			accurate measurements to be made.	in which the speakers are facing.
	Retry			• Adjust the subwoofer’s volume.
	Cancel
[ENT]:Retry
	Caution		• The displayed speaker could not be detected.	• Check the connections of the displayed speaker.
		MultEQ

Front

R:None

Retry

Cancel Skip

[]:Up/Down [ ]:CH

Caution			• The displayed is connected with the polarities	• Check the polarities of the displayed speaker.
			reversed.	• For	some speakers,	this	error message may
		MultEQ
				be	displayed even if	the	speaker is properly
	Front
				connected. If you are sure the connection is
	L :Phase
	Retry			correct, press ui to select “Skip”, then press
				ENTER.
	Cancel
	Skip
[ ]:Up/Down [ ]:CH

Parameter Check

This function enables you to check the measurement results and equalizer characteristics after Audyssey Auto Setup.

1 Use ui to select “Parameter Check” and then press ENTER.2 Use ui to select the item you want to check, then press ENTER.

3-2.Parameter Check

Speaker Config.Check

Distance Chenck

Channel Level Check

Crossover Freq.Check

EQ Check

Restore

[ENT]:Select [RTN]:Back

Speaker Config. Check Check the speaker configuration.

Distance Check Check the distance.

Channel Level Check Check the channel level.

Crossover Freq. Check Check the crossover frequency.

EQ Check Check the equalizer.

•If “EQ Check” is selected in step 2, press ui to select equalizing curve (“Audyssey” or “Audyssey Flat”) to be checked.

Use o p to switch the display between the different speakers.

3 Press RETURN.

The confirmation screen reappears. Repeat steps 2 and 3.

Retrieving Audyssey Auto Setup settings

If you set “Restore” to “Yes”, you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ®) even when you have changed each setting manually.

10	Remote control operation	Move the cursor	Confirm the setting	Return to previous menu
	buttons	(Up/Down/Left/Right)