ENGLISH
1 Install | 1 | 2 | 3 | 4 | 5 |
|
2 Connect | 1 | 2 | 3 | 4 | 5 |
|
This unit can perform 2.0/2.1 to
SW
C
22 – 30˚
120˚
Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to the this unit, and be sure to interconnect the channels and polarities correctly.
Connecting the speaker cablesPeel off about 0.03 ft/10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.
NOTE
•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (vpage 70 “Protection
Circuit”).
•Never touch the speaker terminals while the power supply is connected. Doing so could result in electric shock.
•Use speakers with the speaker impedances shown below.
| Speaker terminals | Speaker | |
impedance | ||
| ||
FRONT |
| |
CENTER | 6 – 16 Ω | |
SURROUND | ||
| ||
SURR.BACK / AMP ASSIGN |
|
SL
FL Front speaker (L) FR Front speaker (R)
CCenter speaker SW Subwoofer
SL Surround speaker (L) SR Surround speaker (R)
SR
Listening position
•Install the surround speakers in a position 2 to 3 ft (60 to 90 cm) higher than ear level.
Surround speaker
Front speaker
2 – 3 ft /
60 – 90 cm
Tighten the speaker terminal firmly before inserting the banana plug.
GViewed from the sideH
4 | The “Simple version” describes the installation, connection and setup methods for |
See page 28 for the installation, connection and setup methods for speakers other than