ENGLISH
GHDMIH
Symptom |
| Cause/Solution | Page |
No audio is |
| • Check the connection of the HDMI connectors. | 14 |
output with HDMI | • When outputting HDMI audio from the speakers, set “HDMI | 51 | |
connection. |
| Audio Out” on the menu to “Amp”. |
|
|
| • When outputting HDMI audio from a TV, set “HDMI Audio Out” | 51 |
|
| on the menu to “TV”. |
|
No video is |
| • Check the connection of the HDMI connectors. | 14 |
output with HDMI | • Set the input source to match the connected HDMI connector. | 14, 19, 20 | |
connection. |
| • Check whether the TV is compatible with copyright protection | 14 |
|
| (HDCP). If connected to a device not compatible with HDCP, video |
|
|
| will not be output correctly. |
|
When the following | • Set “HDMI Control” on the menu to “OFF”. To operate power | 32, 51 | |
operations are |
| only for each device, set “Power Off Control” to “OFF”. |
|
performed on |
|
|
|
devices compatible |
|
| |
with HDMI control, |
|
| |
the same operations |
|
| |
occur on this unit. |
|
| |
• Power ON/OFF |
|
| |
• Switching | audio |
|
|
output devices |
|
| |
• Adjust volume |
|
|
|
• Switch input source |
|
| |
GRadioH |
|
|
|
Symptom |
| Cause/Solution | Page |
|
|
| |
Reception fails, or | • Change the antenna orientation or position. | 18 | |
there is a lot of noise | • Separate the AM loop antenna from the unit. | 18 | |
or distortion. |
| • Use an FM outdoor antenna. | 18 |
|
| • Separate the antenna from other connection cables. | 18 |
GiPodH |
|
|
|
Symptom |
| Cause/Solution | Page |
|
|
|
|
iPod cannot be |
| • Check the iPod connections. | 18 |
played. |
| • Plug the control dock for iPod’s AC adapter into a power outlet. | – |
|
| • Switch the input source to “DOCK”. | 19, 20 |
“Connection Error” | • Unable to communicate properly. Turn off the power to this unit, | – | |
is displayed. |
| disconnect the iPod and then reconnect it. |
|
“Not Support” is | • The iPod connected to the unit is not compatible. Please make | 21 | |
displayed. |
| sure the iPod you are connecting is compatible. |
|
|
| • The software version of the connected iPod is an old one. Please | – |
|
| update to the latest version. |
|
“Connection Error” | • The iPod is not responding. Turn off the power to this unit, | – | |
is displayed. |
| disconnect the iPod and then reconnect it. |
|
GRemote control unitH
Symptom | Cause/Solution | Page |
|
|
|
The set cannot be | • Batteries are worn out. Replace with new batteries. | 64 |
operated with the | • Operate the remote control unit within a distance of about 23 ft / | 64 |
remote control unit. | 7 m from this unit and at an angle of within 30°. |
|
| • Remove any obstacle between this unit and the remote control | 64 |
| unit. |
|
| • Insert the batteries in the proper direction, checking the q and | 64 |
| w marks. |
|
| • The set’s remote control sensor is exposed to strong light (direct | 64 |
| sunlight, inverter type fluorescent bulb light, etc.). Move the set |
|
| to a place in which the remote control sensor will not be exposed |
|
| to strong light. |
|
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values.
| ON/STANDBY |
|
| SURROUND MODE 1 | ||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SURROUND MODE 0
1 Turn off the power using ON/STANDBY.2 Press ON/STANDBY while simultaneously pressing SURROUND MODE 0 andSURROUND MODE 1.
3 Once the display starts flashing at intervals of about 1 second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
72