STEP 1

Preparation

4 Connect the setup microphone to the SETUP MIC jack of this unit.

When the setup microphone is connected, the following screen is displayed.

Audyssey Auto Setup

MultEQ XT

Preparation

 

Connect the speakers and place then according to the recommendations in the manual.

Next

[ENTER] Enter

[RETURN] Cancel

5 Select “Next” and then press

ENTER.

6 Use ui to select “Auto Setup Start” and then press

ENTER.

Audyssey Auto Setup

MultEQ XT

Preparation

Set the following items if necessary.

Amp Assign

Channel Select

Auto Setup Start

[ENTER] Enter

[RETURN] Cancel

Here, we explain setup using the example of 5.1-channel speaker

playback.

For settings other than 5.1-channel surround, select “Amp Assign” and perform step 4 to 5 of “Set up “Amp Assign”” (vpage 58).

If unused channels are set with “Channel Select”, measuring time can be shortened. For setting, perform steps 7 to 11 of “Set up “Channel Select”” (vpage 59).

Set up speakers (Audyssey® Auto Setup)

STEP 2

Detect & Measure (Main)

•In STEP 2, you will perform measurements at the main listening position.

•This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency.

It also corrects distortion in the listening area.

7 Select “Measure” and then press ENTER.

When measuring begins, a test tone is output from each speaker.

•Measurement requires several minutes.

8 The detected speakers are displayed.

•The illustration below shows an example of when the front speakers, center speaker, subwoofer, and surround speakers have been detected.

Audyssey Auto Setup

MultEQ XT

Detect Check

Front Yes

Center Yes

Subwoofer Yes

Surround Yes

Retry

Next Measure

[ENTER] Enter

[RETURN] Cancel

NOTE

If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection.

9 Use ui to select “Next → Measure” and then press

ENTER.

16