DistanceUnit : Set the unit of distance. Set distance from listening • Feet / Meters
position to speakers. Step : Set the minimum variable width of the distance.
Measure beforehand the • 1ft / 0.1ft distance from the listening • 0.1m / 0.01m
position to each speaker. Default : The “Distance” settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select “Default” and press ENTER, the “Return settings to the default?” prompt
is displayed. Select either “Yes” or “No”, and press ENTER.
Front L / Front R / Center / Subwoofer / Surround L / Surround R / S.Back Lz / S.Back Rz / F.Height L / F.Height R : Select the speaker. zz When the “Speaker Config.” – “S.Back” setting (vpage 86) is set
to “1spkr”, “S.Back” is displayed.
• 0.0ft – 60.0ft / 0.00m – 18.00m : Set the distance.
• The speakers that can be selected differ depending on the “Amp Assign” (vpage 86) and “Speaker Config.” (vpage 86) settings.
• Default settings :
Front L / Front R / Center / Subwoofer / F.Height L / F.Height R : 12.0 ft (3.60 m)
Surround L / Surround R / S.Back L / S.Back R : 10.0 ft (3.00 m)
• Set the difference in the distance between the speakers to less than 20.0 ft (6.00 m).
NOTE
Speakers set to “None” in “Speaker Config.” (vpage 86) are not displayed.
vSee overleaf
Setting details
Setting items
System Setup

Setting items

Setting details

 

 

Speaker Config.

F.Height : Set the presence and size of the front height speakers.

(Continued)

• Large : Use a large speaker that can adequately play back low

 

frequencies.

 

• Small : Use a small speaker that has inadequate playback capacity for

 

low frequencies.

 

• None : Select when the front height speakers are not connected.

 

NOTE

 

When “Amp Assign” setting (vpage 86) is “F.HEIGHT”, you can

 

make the “F.Height” setting.

Bass Setting

Subwoofer Mode : Select low range signals to be reproduced by

Set subwoofer and LFE

subwoofer.

signal range playback.

• LFE : The low range signal of the channel set to “Small” speaker size is

added to the LFE signal output from the subwoofer.

• LFE+Main : The low range signal of all channels is added to the LFE signal output from the subwoofer.

• “Subwoofer Mode” can be set when “Speaker Config.” – “Subwoofer” (vpage 86) is set to “Yes”.

• Play music or a movie source and select the mode offering the strongest bass.

• Select “LFE+Main” if you want the bass signals to always be produced from the subwoofer.

NOTE

If “Front” and “Center” for “Speaker Config.” are set to “Large”, and “Subwoofer Mode” is set to “LFE”, no sound may be output from the subwoofers, depending on the input signal or selected surround mode.

LPF for LFE : Set LFE signal playback range. Set this when you want to change the playback frequency of the subwoofer.

•80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz / 250Hz

BD

87

version Basic

version Advanced

Information