STEP 5 | STEP 6 |
| Check | Store |
Set up speakers (Audyssey® Auto Setup)
Finishversion Basic
13Use ui to select the item you want to check, and then press
ENTER.
Audyssey Auto Setup |
| MultEQ XT |
|
|
|
Check |
|
|
Check processing resuit. |
|
|
To proceed, press |
|
|
“Next”. |
|
|
Sp.Config. Check |
|
|
Distance Check |
|
|
Ch.Level Check |
|
|
Crossover Check |
|
|
Next Store |
|
|
[ENTER] Enter | [RETURN] Cancel | |
|
|
|
•Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers.
•If you want to check another item, press RETURN B.
14Use ui to select “Next → Store” and then press
ENTER.
NOTE
•If the result differs from the actual connection status, or if “Caution!”
is displayed, see “Error messages” (vpage 19). Then carry out Audyssey® Auto Setup again.
•If you change speaker positions or orientation, perform Audyssey® Auto Setup again to find the optimal equalizer settings.
15Select “Store” and then press ENTER. Save the measurement results.
Audyssey Auto Setup | MultEQ XT |
Store
Press “Store” to store calculation result.
Store
[ENTER] Enter | [RETURN] Cancel |
Audyssey Auto Setup | MultEQ XT |
Store
Now storing
Please wait
0%
•Saving the results requires about 10 seconds.
•If the measuring results are not to be saved, press RETURN B.
A message “Cancel Auto Setup?” will be displayed. Press o then select “Yes”. All the measured Audyssey® Auto Setup data will be erased.
• During saving of measurements results, “Now storing Please wait...” is displayed. When saving is completed, “Storing complete. Auto Setup is now finished.” is displayed.
NOTE
During saving of measurement results, be sure not to turn off the power.
16Unplug the setup microphone from the unit’s SETUP MIC jack.
17Set Audyssey Dynamic Volume®.
Audyssey Auto Setup | MultEQ XT |
Finish
Storing complete.
Auto Setup is now finished.
Please unplug microphone.
Turn on Dynamic Volume? 
Yes
No
[ENTER] Exit
•This feature adjusts the output volume to the optimal level while constantly monitoring the level of the audio input to the unit. Optimal volume control is performed automatically without any loss in the dynamism and clarity of the sound when, for example, the volume suddenly increases for commercials shown during television programs.
nn When turning Dynamic Volume® on
•Use u to select “Yes”, and then press ENTER. The unit automatically enters “Evening” mode.
nn When turning Dynamic Volume® off
•Use i to select “No”, and then press ENTER.
NOTE
After performing Audyssey® Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey® Auto Setup again.
version Advanced
Information
18