the kick panel area and secure it. Probe one of the thicker gauge wires. The color and identity of your specific vehicle wiring can be obtained at www.designtech-intl.com. With the key in the off position, test the suspect wire. The constant power wire will illu- minate the Red LED on the test probe.

warning! Before making any connection to constant battery power make sure that the two green 30 amp fuses are removed from the fuse holders on the two thick red wires (heavy gauge wires). Failure to do so may cause fire or shorting of sensitive elec- trical components.

30 A

fuses

Control Module

RED heavy gauge wires

Once the constant power wire has been identified, solder the two heavy gauge RED wires from the control module (relay heavy gauge) to it and wrap the connection with electrical tape.

note: If the vehicle has two constant power wires, utilize both constant power wires. Connect one of the heavy gauge RED wires to one of the constant power wires and the other heavy gauge RED wire to the other constant power wire.

With the test probe black lead still in the kick panel, locate the ignition wire in the same location. It will test differently than

© 2 0 0 6 D i r e c t e d E l e c t r o n i c s

15

Page 19
Image 19
Directed Electronics Ready Remote manual Control Module