step 11

Testing the system

Once steps 1-10 have been completed, the operation of the system can be tested.

note: If power has been removed or the fuses removed, the remote(s) will have to again be learned to the system.

Ensure that the two 30-amp fuses are in the relay harness RED wire fuse holders. Make sure that the vehicle is in park with the

emergency brake on and the hood closed. Press once on the remote to initiate the remote start function. The parking lights should flash to confirm the remote start command has been received, The accessories and ignition should turn on followed by the starter cranking and the vehicle engine running (this may

take a moment to initiate). Pressing once again on the remote will shut the engine off.

This completes the testing, if all functions do not work correctly check your wiring against the manual and verify all connections. If you still experience problems contact Directed Technical Support at 1-800-477-1382.

© 2 0 0 6 D i r e c t e d E l e c t r o n i c s

47

Page 51
Image 51
Directed Electronics Ready Remote manual Testing the system