Place the wire with the spade connector onto the pin switch and run the wire into the vehicle’s passenger compartment through a factory rubber grommet. Using a sharp, pointed object poke a hole into the grommet and attach the wire to the object with electrical tape. Pull the wire through the grommet taking extra care to keep the wire away from any moving parts or anything that will generate extreme heat. Once the wire is run into the vehicle and secured from any moving parts, solder the wire to the GRAY (H1/4) wire of the main harness and wrap the connection with electrical tape.
warning! This wire MUST be connected. Do not use the vehicle until you confirm the oper- ation of the hood pin shutdown. Improper operation could result injury or death.
The bypass toggle switch is designed to bypass the remote start in an emergency or to disable the remote start functions temporarily (i.e., for service on the vehicle or when parking in an enclosed area). This switch is to be mounted in an easily acces- sible location in the passenger compartment.
Connect the toggle switch as shown below. The Gray (H1/4) wire to the hood pin switch, and the Black wire from the switch to ground. The toggle switch must be in the Off position for normal operation.
22 | © 2 0 0 6 D i r e c t e d E l e c t r o n i c s |
