during normal driving. If it finds a valid tachometer signal the module will use tachometer mode, otherwise the module will use voltage mode (battery voltage will rise after the engine starts).

note: If only voltage mode is desired for remote start, the Violet/White wire (H1/2) does not need to be connected.

To program tachometer mode:

1.Start the engine.

2.Simultaneously press and hold the PROG and buttons on the transmitter within 25 seconds of starting the engine.

3.The parking lights will turn on and stay on until the buttons on the transmitter are released. The unit is now programmed with tachometer.

note: If the parking lights never turn on, the unit remains in voltage mode.

The system is programmed to attempt two starts using tachometer mode (monitored through the Violet/White wire [H1/2]). If after the second start attempt the control module did not see a tachometer input the system will automatically program itself to voltage engine monitoring mode. Check the tachometer wiring and then repeat the previous steps for tachometer programming.

52

© 2 0 0 6 D i r e c t e d E l e c t r o n i c s

Page 56
Image 56
Directed Electronics Ready Remote manual 0 6 D i r e c t e d E l e c t r o n i c s