Setting
Ceiling
When this function is "On", the picture is top/bottom and left/right reversed. This function is used to project the image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right reversed. This function is used to project the image to a rear projection screen.
Standby mode
This function is available when the projector is turned off and in
Normal . . . . . . . . . . normal power consumption in
Eco. . . . . . . . . . . . . lower power consumption than Normal mode in
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not used for a certain period.
When the input signal is interrupted and no button is pressed for more than 30 seconds, the timer display with "No signal" appears. The countdown starts to turn off the lamp.
Select one of the operations:
Ready. . . . . . . . When the lamp has been fully cooled down, the POWER indicator changes to green blinking. In this condition, the projection lamp is turned on if the input signal is reconnected or any button on the top control or remote control is pressed.
Shut down . . . . When the lamp has been fully cooled down, the power is turned off.
Off . . . . . . . . . . Power management function is off.
Then set the countdown timer with the Point ◄►buttons.
Note:
Factory default is " Ready, 5 min".
Ceiling
Rear
Power management
Time left before Lamp is off.
Press the SELECT button at Power management and this box appears. Choose one of three settings with the Point ◄
►buttons, and go to the
timer with the Point ▲▼ buttons and set time with the Point ◄►buttons.
50
