Maintenance and Care
Follow these steps to replace the lamp.
1 | Turn off the projector and disconnect the AC power |
| cord. Allow the projector to cool for at least 45 |
| minutes. |
2 | Loosen the screw with a screwdriver, slide and open |
| the lamp cover. |
3 | Loosen 2 screws of the lamp with a screwdriver and |
| pull out the lamp upwards vertically by grasping the |
| handle. |
4 | Replace the lamp with a new one and tighten the 2 |
| screws back into position. Make sure that the lamp is |
| set properly. Replace the lamp cover and tighten the |
| screw. |
5 | Connect the AC power cord to the projector and turn |
| on the projector. |
6 | Reset the lamp replacement counter.. |
| See "Resetting the Lamp Counter" on the next page . |
Screw
Lamp Cover
Screw
Handle Screw
Lamp
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.
● Model No. of your projector | : |
● Replacement Lamp Type No. | : |
| (Service Parts No. 610 339 8600) |
61
