Maintenance and Care

Lamp Replacement

When the life of the projection lamp of this projector

Top Control

draws to an end, the Lamp replacement icon appears on

 

the screen and LAMP REPLACE indicator lights yellow.

 

Replace the lamp with a new one promptly. The timing

 

when the LAMP REPLACE indicator should light is

 

depending on the lamp mode.

 

This indicator is yellow w h e n t h e l i f e o f t h e projection lamp draws to an end.

Lamp replacement icon

Note:

The Lamp replacement icon will not appear when the Display function is set to “Off” (p.47), during “Freeze” (p.23), or “No show” (p.24).

CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

CAUTION

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.

If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.

Refer to the next page for replacing a lamp.

60

Page 60
Image 60
Eiki LC-XS25, LC-XS30 owner manual Lamp Replacement, Lamp replacement icon Note