Emerson 3081FG instruction manual SW Build Number, SW Build Date, Calcheck Menu

Model 3081FG

Instruction Manual

IB-106-3081 Rev. 1.5 September 2002

	j.	SW BUILD NUMBER
		Use this screen to see the software build
		number for the Model 3081 Transmitter.
		Pressing NEXT accesses the SW BUILD
%		DATE screen.
	k.	SW BUILD DATE
		Use this screen to see the software build	3
		date for the Model 3081 Transmitter.
		Pressing NEXT returns to the beginning of
		the DIAGNOSTICS MENU branch (the
		SHOW FAULT screen).

CELL	3-7 CALCHECK MENU
TEMPERATURE
MAXIMUM	The CALCHECK MENU branch of the menu
26020021
Figure 3-26. MAX CELL T	tree (Figure 3-5)allows you to perform a cali-
	bration check of the analyzer. Before performing
	a calibration check, ensure the high calibration
g. MAX CELL T	check gas and low calibration check gas O2
	percentages are entered into the electronics via
Refer to Figure 3-26. Use this screen to ex-	the PROGRAM MENU. To set these values,
amine the maximum temperature attained	refer to paragraphs 3-5jand 3-5k.
by the O2 cell. This value can be reset under	Once these values are set, access the CAL-
the PROGRAM MENU. Pressing NEXT
accesses the SW VER screen.	CHECK MENU branch by pressing CAL on the
	IRC when in the PROCESS DISPLAY screen
h. SW VER	(Normal or Faulted). Each screen in this branch
	identifies a process step in the calibration check
Use this screen to see the software version	procedure. The first screen in the sequence is
number for the Model 3081 Transmitter.	the IN MANUAL? screen.
Pressing NEXT accesses the UNIT SER #
screen.
i. UNIT SER #
Use this screen to see the unit serial num-
ber for the Model 3081 Transmitter. Press-
ing NEXT accesses the SW BUILD
NUMBER screen.

Rosemount Analytical Inc. A Division of Emerson Process Management Startup and Operation 3-13