System Management: Ven dor C omman ds
10009109-01 ATCA-9305 User’s Manual 7-39
Get Local FRU LED State The Get Local FRU LED State command is used to read the local state of a FRU LED.
Table 7-39: Get Local FRU LED State Command
Type: Byte: Data Field:
Request Data 1:3 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
4 FRU Device ID
5LED ID
00h Blue LED (Hot Swap)
01h LED 1 (OOS)
02h LED 2
03h LED 3
04h-FEh OEM defined LEDs
FFh reserved (all LEDs under management control are
addressed)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID, MS Byte first
0x00400A = 16394 (Pigeon Point Systems)
5 Local Control LED Function
00h LED is off (default if Local Control not supported)
01h-FAh LED is blinking O ff duration specified by this byte,
on duration specified by byte 5 (in tens of
milliseconds)
FBh-FEh reserved
FFh LED is on
6 Local Control On Duration
LED on-time is measured in tens of milliseconds
Lamp Test time in hundreds of milliseconds if byte 4=FBh, time
value must be less than 128. Other values when Byte 4=FBh are
reserved. Otherwise, this field is ignored and shall be set to 0h.
7 Color parameter specifies the color of the LED in the local state for
multi-color LEDs
8 If the off-first flag parameter is 0, the on part of the blink cycle of
the LED precedes the off part of the cycle. Otherwise, the off part
of the blink cycle precedes the on part of the cycle.