Emerson ATCA-9305 Regulatory Agency Warnings & Notices

10009109-01 ATCA-9305 User’s Manual i

Regulatory Agency Warnings & Notices

The Emerson ATCA-9305 meets the requirements set forth by the Federal Communications

Commission (FCC) in Title 47 of the Code of Federal Regulations. The following information

is provided as required by this agency.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, in cluding interference t hat may cause undesired opera-

tion.

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-

able protection again st harmful inter ference when the eq uipment is operate d in a commer-

cial environment. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. Operation of this equipment in a residential area is likely

to cause harmful interference, in which case the user will be required to correct the interfer-

ence at his own expense.

Caution: Making changes or modifications to the ATCA-9305 hardware without the explicit consent

of Emerson Network Power could invalidate the user’s authority to operate this equipment.

The electromagnetic compatibility (EMC) tests used an ATCA-9305 model that includes a

front panel assembly from Emerson Network Power.

Caution: For applications where the ATCA-9305 is provided without a front panel, or where the front

panel has been removed, your system chassis/enclosure must provide the required

electromagnetic interference (EMI) shielding to maintain EMC compliance.

Caution: WARNING: The intra-building port(s) of the equipment or subassembly is suitable for

connection to intrabuilding or unexposed wiring or cabling only. The intra-building port(s)

of the equipment or subassembly MUST NOT be metallically connected to interfaces that

connect to the OSP or its wiring. These interfaces are designed for use as intra-building

interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE, Issue 4) and require

isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient

protection in order to connect these interfaces metallically to OSP wiring.