Operation
10.0OPERATION
The XDF is intended for operation with its doors closed and latched. This increases efficiency and keeps out dust and humidity.
With the doors closed, the XDF will achieve full capacity in ambient conditions up to 95°F (35°C) and 40 percent relative humidity. The XDF’s cooling efficiency is reduced if it is operated in higher ambi- ent temperatures and humidity. The reduction varies according to the heat load from the installed equipment and the external temperature and humidity.
The XDF may be operated for short periods with its doors open. Refer to Figure 10.7 - Operation With the Door Open.
10.1Environmental Control
The XDF’s cooling functions are controlled by Liebert’s iCOM control module. This section describes the iCOM’s basic functions, such as
NOTE
The iCOM installed on the XDF is programmed for
The
Remote
The iCOM controller on the XDF may be remotely accessed with Liebert’s SiteScan systems, Modbus or with SNMP.
Each XDF is equipped with Intellislot bays for use with optional communication cards:
•OpenComms
•OpenComms
10.2iCOM Components and Functions
The iCOM controller layout is shown in Figure 29.
Figure 29 iCOM display components
Liquid Crystal
Display screen
LED Status Indicators (top LED is red or flashing red; bottom LED is green or amber)
Keypad
39
