Emerson XDF user manual Accessing Menus and Settings Viewing Data, Entering the Password

Operation

10.3.1Accessing Menus and Settings Viewing Data

No password is required to view data or settings. To view data:

1.From the default screen, press the Enter key to view the opening page of the six-page user menu (see Figure 32).

2.Press Enter again to highlight the password line.

3.Use the Down arrow to scroll to the icon for the data you wish to view.

4.Once that icon is highlighted, press Enter again to display the data.

If there are lines above or below what is shown on the screen, small arrows in the top right corner and bottom right corner will be displayed (see Figure 33).

5.Press Enter to select the first line of data.

6.Use the Up and Down arrow keys to scroll to the desired data point.

7.Press ESC to move back to higher level menus.

Figure 32 iCOM user menu, Page 1 of 6			Up and Down Arrows show additional
USER MENUS 1/6
			page.
			pages are above and below the current
PASSWORD LEVEL0		????	Left and Right Arrows show additional
			Note: Although Service and Advanced
			screens and menus are available.
			menus may be viewed, changes may be
C / F			made only by factory-authorized service
	SETPOINTS		personnel.
% RH
			Password command
SET			line—highlight by
			pressing Enter

Figure 33 Accessing additional menu lines

DISPLAY SETUP

U404 TEMP F / C	°F
U405 CONTRAST	50%
U406 BUZ FREQ	50%

Arrows show there are additional lines above and below

10.3.2Entering the Password

1.From the default screen, press the Enter key to access the opening page of the six-page user menu (see Figure 32).

2.Press Enter to highlight the Password command line.

3.With the password line highlighted, press Enter to highlight the first digit in the password; enter the password, 1490.

4.Use the Up and Down arrow keys to select a numeral for the first digit of the password.

5.Move to the next digit of the password with the Right arrow key.

6.Select the numerals for all four digits with the same process.

7.After all four digits of the password have been entered, press the Enter key.

NOTE

Do not press the ESC key or the iCOM will move to the previous screen and the password must be re-entered before changes may be made.

42