Chapter 2 Getting started
Page 2.7
Sig
+
Neg
(24v) Power +
1
2
3
Klippon D-type
PL5/9
PL5/5
PL5/6
PL5/10
SK6/22
SK6/18
SK6/19
SK6/24
79513096/3098
Barrier as defined in the
latest 3096/3098
specification
1
2
3
4
(0v) Power -
Signal -
Signal +
Intrinsically Safe Earth
Figure 2.7: Hazardous area wiring for a 3096/3098
Turn on the
power
3. Turn on the power to the system. The system goes through a Power On Self Test
(POST) routine which takes less than 30 seconds. When it is finished, ignore any
flashing alarm lights which may appear.
Go to the
wizards menu
4. Press the MENU button to go to Page 1 of the Main Menu (if you aren’t there already).
5. Press the DOWN-ARROW button twice (to go to page 3 of the menu).
6. Press the b-button to select “Configure”.
7. Press the a-button twice to go to the wizards menu.
Clear existing
configuration
(This is optional)
8. Press the b-button then the UP-ARROW or DOWN-ARROW button to scroll through the
option list until “Initialise” is shown.
9. Press the b-button to select “Initialise”.
10. Press the d-button to confirm that you want to lose the current configuration.
11. Wait a few seconds until “initialise” on line 2 of the display changes back to
“Choose option”.
Select the
wizard
12. Press the b-button then the UP-ARROW or DOWN-ARROW button to scroll through
the option list until “SG 1” is shown.
13. Press the b-button to select “SG 1”.
Start of wizard 14. Press the d-button to answer YES to the question “Edit Gravitometer A?”.
Enter
gravitometer
calibration
factors
15. Press the b-button, then input the factor K2 from the Calibration Certificate that was
shipped with the meter.
16. Press the b-button then ENTER to confirm the K2 value.
17. Press the b-button, then input the factor K0 from the Calibration Certificate that was
shipped with the meter.
18. Press the b-button then ENTER to confirm the K0 value.
Skip over other
questions
19. Press the c-button several times (to answer NO to all questions) until the wizard is
exited.
View how you
have configured
Specific gravity
20. Press the MENU button.
21. Press the c-button and then press the a-button. The display looks similar to that
shown in Figure 2.8 although values shown may vary.