Chapter 10 Configuring your instrument by using wizards Page 10.2
"Option n"
"Option 1" "Option 2"
Heading
Option 1
Option 2
Option n
An item prompt that appears with the name of the item
along with programmable properties - a value, units of
measurement and present status. Edit properties and then
press the enter key for wizard to continue.
An arrow indicates where a wizard will continue to. It may
(or may not) have a label to identify a particular path the
wizard is taking
The shaded areas indicate a situation where there are two
or more options. Choosing an option here may influence
the subsequent path taken by the wizard.
Pressing the 'b' key, when this screen first appears, starts
the selection process. The up / down arrow keys cycle
through available options.
Pressing the enter key confirms the option displayed as
the one chosen. Pressing enter a second time makes the
wizard continue.
This format indicates a situation where there are two or more
options. Choosing any option here will determine the
subsequent path taken by the wizard.
Note that all of the options are always shown in this box.
However, the 795x splits options into pages.
The wizard selection screen is always shown
after exiting a wizard
Route will be continued where there is a unique connector
with a matching code. Note that the letter in the code is
unique to a wizard - A is used for the Flow meter wizard
(Orifice route).
Route continues from a connector with a matching code.
The letter in the code is unique to a wizard - A is used for
the Flow meter wizard (Orifice route).
A1
A1
Exit wizard
This represents the selection of the wizard. It is the start
point for every wizard.
Pressing the 'b' key or the enter key confirms the
selection.
This provides information for a prompt that follows. For
example, in the Line Density wizard, the value of nwill be
seen to complete a PTZ descripor. PTZ n will be PTZ 1 when
n=1. PTZ n will be PTZ 2 when n=2.
Heading
(Selection)
Selection 1
Selection 2
Selection n
etc.
n=1
Programmable item
An item prompt with a dotted outline will not always
appear. A note alongside states the condition needed for
it to appear.
'b' key
Setup wizard
Wizard
Programmable item
Figure 10.2: Key to wizard map conventions