Chapter 2 Getting started
Page 2.13
Turn on the
power
4. Turn on the power to the system. The system goes through a Power On Self Test (POST)
routine which takes less than 30 seconds. When it is finished, ignore any flashing alarm
lights which may appear.
Go to the
wizards menu
5. Press the MENU button to go to Page 1 of the Main Menu (if you aren’t there already).
6. Press the DOWN-ARROW button twice to go to Page 3 of the menu.
7. Press the b-button to select “Configure”.
8. Press the a-button twice to go to the wizards menu.
Clear existing
configuration
(This is optional)
9. Press the b-button then the UP-ARROW or DOWN-ARROW button to scroll through the
option list until “Initialise” is shown.
10. Press the b-button to select “Initialise”.
11. Press the d-button to confirm that you want to lose the current configuration.
12. Wait a few seconds until “initialise” on line 2 of the display changes back to
“Choose option”.
Select the wizard 13. Press the b-button then the UP-ARROW or DOWN-ARROW button to scroll through the
option list until “Pressure” is shown.
14. Press the b-button to select “Pressure”.
Start of wizard 15. Press the d-button to answer YES to the question “Edit Line Pressure?”.
Choose the
Analogue Input
16. Press the b-button
17. Press the UP-ARROW button until “mA input 3” appears.
18. Press the b-button and then the ENTER button to confirm selection of “mA input 3”.
Set Analogue 0%
and 100% range
19. Press the b-button.
20.Type in a suitable maximum pressure value and then press the ENTER button.
21. Press the ENTER button to move on to the next prompt
22. Press the b-button
23. Type in a suitable minimum pressure value and then press the ENTER button.
24 Press the ENTER button to move on to the next prompt
Select the type
of Analog Input
25. Press the ENTER button to keep the default selection of a 4-20mA type input.
Make the
Analogue Input
“live”
26. Press the d-button
27. Press the UP-ARROW button so that “Set” changed “Live”
28. Press the ENTER button twice
Skip over other
questions
29. Press the c-button several times to answer NO to all questions until the wizard is exited
View how you
have configured
Line pressure
30. Press the MENU button.
31. Press the DOWN-ARROW button.
32. Press the a-button twice. The display looks similar to that shown in Figure 2.13 although
values shown may vary.
Figure 2.13: Line pressure data display
End of Worked Example 4