Enterasys Networks N Standalone (NSA) Series Routing Protocol Configuration

Matrix NSA Series Configuration Guide 13-1

Routing Protocol Configuration

This chapter describes the Routing Protocol Configuration set of commands and how to use them.

Use the following steps as a guide to configuring routing protocols on the device:

1. Activating advanced routing features (Section 13.2.1)

2. Configuring RIP (Section 13.2.2)

3. Configuring OSPF (Section 13.2.3)

4. Configuring DVMRP (Section 13.2.4)

5. Configuring IRDP (Section 13.2.5)

6. Configuring VRRP (Section 13.2.6)

ROUTER: The commands covered in this chapter can be executed only when the

device is in router mode. For det a ils on how to enab le router configu ra tion mo des, re fer

to Section 2.3.3.

NOTE: The command prompts used in examples throughout this guide show a system

where module (or standalone device) 1 and VLAN 1 have been configured for routing.

The prompt changes depending on your current configuration mode, the specific

module, and the interface types and numbers configured for routing on your system.