Security Configuration Command Set
Configuring MAC Locking
Matrix NSA Series Configuration Guide 14-123
14.3.9.3 set maclock enable
Use this command to enable MAC locking on on e or more ports. When enabled and configured for
a specific MAC address and port string, this locks a port so that only designated end station
addresses are allowed to participate in frame relay.
set maclock enable [port_string]
Syntax Description
Command Defaults
If port_string is not specified, MAC locking will be enabled on all ports.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable MAC locking on fe.2.3:
NOTE: MAC locking is disabled by default at device startup. Configuring one or more
ports for MAC locking r equire s glo ba lly enablin g it o n the d evice a nd then e nab ling it on
the desired ports as described in Section 14.3.9.5.
port_string (Optional) Enables MAC locking on specific port(s). For
a detailed description of possible port_string values, refer
to Section 4.1.1.
Matrix(rw)->set maclock enable fe.2.3