Preparing the Device for Router Mode
Pre-Routing Configuration Tasks
2-138 Matrix NSA Series Configuration Guide
The example in Figure 2-8 shows how to:
•Configure module 1 as a routing module.
Table 2-9 Enabling the Switch for Routing
To do this task... Type this
command... At this prompt... For details,
see...
Step 1 Configure a routing
module. set router module Switch:
Matrix (rw)-> Section 2.3.2.2
Step 2 Enable router mode. router module Switch:
Matrix (rw)-> Section 2.3.2.4
Step 3 Enable router
Privileged EXEC
mode.
enable Router:
Matrix>Router1> Section 2.3.3
Step 4 Enable global router
configuration mode. configure
terminal Router:
Matrix>Router1# Section 2.3.3
Step 5 Enable interface
configuration mode
using the interface of
the routing module.
interface {vlan
vlan-id | loopback
loopback-id
Router:
Matrix>
Router1(config)#
Section 12.2.1.2
Step 6 Assign an IP address
to the routing
interface.
ip address
{ip-address
ip-mask}
Router:
Matrix>Router1
(config-if (Vlan 1 |
Lpbk 1))#
Section 12.2.1.5
Step 7 Enable the interface
for IP routing. no shutdown Router:
Matrix>Router
(config-if (Vlan 1 |
Lpbk 1))#
Section 12.2.1.6
NOTE: A module designation of 1 mu st be entered to enable routing on the Ma trix NSA
standalone device. All other values will result in an error message.