Enterasys Networks N Standalone (NSA) Series 2.2.7 Starting and Configuring Telnet, Commands

1 1372

General Configuration Command Set

Starting and Configuring Telnet

2-100 Matrix NSA Series Configuration Guide

2.2.7 Starting and Configuring Telnet

Purpose

To enable or disable Telnet, and to start a Telnet session to a remote host. The Matrix Series device

allows a total of four inbound and / or outbound Telnet session to run simultaneously.

The commands used to enable, start and configure Telnet are listed below and described in the

associated section as shown.

•show telnet (Section 2.2.7.1)

•set telnet (Section 2.2.7.2)

•telnet (Section 2.2.7.3)

•show router telnet (Section 2.2.7.4)

•set router telnet (Section 2.2.7.5)

•clear router telnet (Section 2.2.7.6)