Calibrating the Printer From the Control Panel
If for some reason you cannot use any of the calibration utility programs that came with your printer, you can calibrate the printer from the control panel. This is called the Printer adjustment mode. Follow these steps:
1.Make sure the printer is turned off and paper is loaded.
2.Hold down the Cleaning O and Load/Eject buttons and turn on the printer to enter the Printer adjustment mode.
The printer prints an instruction sheet in English, French, German, Italian, and Spanish that shows you how to calibrate your printer. Follow these instructions.
3.After calibrating the printer, exit the Printer adjustment mode by turning off the printer.
Transporting the Printer
If you need to transport your printer, follow these steps:
1.Make sure the printer is turned off.
2.Open the printer cover and make sure that the print heads are locked in the far right position. If not, turn on the printer, wait about 10 seconds, and turn it off.
Caution:
c Do not remove the ink cartridges when transporting the printer. Transporting the printer without the cartridges installed can damage the printer.
3.Unplug the power cord from the electrical outlet.
4.Disconnect the interface cable from the printer.