Epson 830p Solving EasyManagement Problems, Solving Problems with the Remote Control, Try restarting your computer, ■Try restarting your computer

Solving EasyManagement Problems

You don’t see your projector in the EMP Monitor window.

■Make sure that you’ve connected the projector to the network and configured it correctly; see page 80. Also, make sure you’ve registered the projector with EMP Monitor; see page 81.

■Make sure that Standby Mode in the projector’s Extended menu is set to Network ON.

■If the computer you are using is running Windows XP or 2000, you must be logged in as the Administrator.

■Try restarting your computer.

Solving Problems with the Remote Control

The projector doesn’t respond to remote control commands.■Be sure the ON/OFF switch is in the ON position, as shown on page 19.

■The remote control’s batteries may not be installed correctly or may be low on power. To change the batteries, see page 33.

■Make sure your remote control’s ID is set to 0 or to the projector’s ID; see page 73.

■Make sure you are within about 33 feet (10 meters) of the projector and within range of the projector’s front or back sensor (approximately 20° to the left or right and 40° above or below).

■Dim the room lights and turn off any fluorescent lights. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector’s infrared receivers. Also, turn off any nearby equipment that emits infrared energy, such as a radiant room heater.

Solving Problems 111