Replacing the BatteriesIf the projector stops responding to the remote control, check the following:■Make sure the remote control’s ON/OFF switch is in the ON position.

■Press the light button and check to see if the buttons on the remote control light up. (If you’re in a bright room, you may not be able to see them light up.)

If the buttons do not light up, replace the batteries as described below:1.Turn the remote control over.2.Press down on the ridges at oneend of the battery cover as you slide the cover off.3. Install two AA batteries, inserting the flat (negative) ends in first.4. Slide the cover back in place.

caution

When replacing batteries, take the following precautions:

■Replace the batteries as soon as they run out. If the batteries leak, wipe away battery fluid with a soft cloth. If fluid gets on your hands, wash them immediately.

■Do not expose batteries to heat or flame.

■Dispose of used batteries according to local regulations.

■Remove the batteries if you won’t be using the projector for a long period of time.

Using the Remote Control 33