■To change the network addresses from the projector’s control panel, press the right and left arrow buttons to select the part of the address you want to enter, then use the up and down arrow buttons to increase or decrease the numeric value.

Increase or decrease the value

Select the part of the address to change

When you finish changing an address in the network menu, press the Enter button (on the remote control) or the Auto/Enter button (on the projector).

5. When you’re done, press Esc to exit the menu system.

Using EMP Monitor

EMP Monitor lets you use a remote computer to manage your projectors over a wired network. It lets you easily turn the projectors on or off (together or individually), switch image sources, and check their status.

Before using EMP Monitor, make sure you’ve installed the software (available for Windows only) as described on page 114. The computer you’re using to monitor the projector should already

be connected to your network.

note

If you want to monitor projectors while they are in standby mode, select Standby Mode in the Extended menu, then select Network ON. See page 75.

Managing Projectors 81