Epson 830p Remote Control Information, ■Ambient light is too bright, ■Certain types of fluorescent lighting are used, ■A strong light source shines into the IR receiver

Remote Control Information

You can operate the projector by remote control via a line-of-sight infrared (IR) receiver at the front and rear of the projector. The projector may not respond to remote control commands under the following conditions:

■There is an object between the remote control IR emitter and the IR receiver on the projector.

■Ambient light is too bright.■Certain types of fluorescent lighting are used.■A strong light source shines into the IR receiver.

■Other equipment that emits infrared energy, such as a radiant room heater, is in the room.

These conditions commonly cause problems for most infrared-controlled equipment. Try the following:

■The remote control’s batteries may be low on power; replace them.■Dim the ambient lighting and/or turn off any fluorescent lights.■Close any window coverings and/or move the projector out of direct sunlight.■Turn off other equipment that emits infrared energy.

Notices 123