Epson 830p You can give the projector a, 5.Click Mail Notification Settings, 3.EMP NetworkManager connects to the projector, and you see this screen:

3.EMP NetworkManager connects to the projector, and you see this screen:

4.Verify that the network settings are correct. (If DHCP is on, you don’t need to verify network settings.)

■Make any desired changes to the projector’s network address configuration (turning off DHCP enables the manual settings).

■You can give the projector a name—up to 15 characters long, including the following symbols: ! @ # $ % ^ & ' . - _ { } ~

Naming the projector helps you identify it in EMP Monitor and EMP NetworkManager, especially if you’re managing more than a few of them.

5.Click Mail Notification Settings.

note

The projector must be plugged in (projecting or in Standby Mode) for you to be able to connect to it.

To access a projector in Standby Mode, you must select Network ON as the Standby Mode setting in the projector’s menu system (see page 75).

Remember that when Standby Mode is set to Network ON, the exhaust fan continues to operate after the projector has cooled down. This is normal.

Managing Projectors 91