Epson DFX-5000+ Running the self test, and, LF/FF, TEAR OFF, the LF/FF, 1-18 Set Up and Print, While holding down the

Running the self test

The self test can be run in either draft or near letter quality (NLQ) mode.

1.While holding down the LF/FF button (for draft mode) or TEAR OFF button (for NLQ mode), turn on the printer. After printing starts, release the button.

The printer prints a series of characters. Here is part of a typical self test printout in high-speed draft.

Note:

When NLQ quality is selected using DIP switch l-3, the serf test runs in NLQ mode even if you press the LF/FF button.

2.The self test continues until the paper runs out or until you press the PA USE button. If the test results are satisfactory and you wish to stop the test, press the PAUSE button. (To resume the test, press the PAUSE button again.)

3.To end the self test, press the PA USE button to stop printing and then hold down the LF/FF button to advance the paper.

1-18Set Up and Print