6.Open the paper bail using the tab on its right side. Then tilt the pull tractor back until its rear latches click into place over the printer’s rear mounting pins.

7.Gently close the paper bail (do not apply excess pressure), and then close printer’s top cover.

Using the pull tractor with the front tractor

If you are using labels or multi-part forms with more than four parts (including the original), you should use the pull tractor with the printer’s built-in front tractor.

You can switch between the front and rear tractors at any time when you are using the pull tractor. Just press the FRONT/REAR button and then use the LF/FF button to feed the paper the additional distance to the pull tractor. (Labels require special handling. See the section on using labels in Chapter 2.)

Using the Printer Options

4-5