3.2 RS-485 installation with EverFocus DVR | EverFocus EPTZ 100

3.2.3.2 RS-485 installation with EverFocus DVR

It is possible to control the EPTZ 100 speed dome by EverFocus DVR (except 1 Ch. models) via network. A combined local control by EKB 500 keyboard and remote (network) control by DVR is also possible.

For a combined local and remote PTZ control, it is mandatory that DVR and speed dome are connected to the same RS-485 port of the EKB 500 keyboard. The RS-485 signal is looped through the DVR.

Combined local and remote PTZ control

Combined local and remote PTZ control with star wring to dome and RS-485 distributor

The drawing below shows an incorrect RS-485 connection for controlling the DVR locally and remotely. With this way of installation, only local PTZ control is possible.

Incorrect wring for combined local and remote PTZ control

18	EPTZ100_ma_en_rev03.doc

Image 18

EverFocus EPTZ 100 manual 3.2 RS-485 installation with EverFocus DVR

Contents

Eptz Safety Warnings Weee Table of Contents Device Setting Camera Introduction FeaturesOptional Accessories Delivery Scope Camera SpecificationsAlarm Communication Power Physical / environment Dimensions Dimensions with ceiling mount adapterDimensions with recessed ceiling mount adapter Dimension Eptz 100 with wall mount bracket Eptz 100 WLM Dimensions wall bracket Eptz 100 WLM Dimension Eptz 100 with ceiling pendant bracket Eptz 100 CPM Dimension ceiling pendant bracket Eptz 100 CPM Installation MechanicalCeiling mount Recessed ceiling mount Wall mount Ceiling pendant mount Power ElectricalVideo 3 RS-485 3.1 RS-485 installation with EKB 500 keyboard 3.2 RS-485 installation with EverFocus DVR Alarm Communication Settings Baud rate and Protocol 2 RS-485 ID address EPTZ100maenrev03.doc Initial Start OSD Menu SetupOperation in Setup Menu 3 RS-485 bus termination Menu Structure OSD Structure Part Control Main menu System infoDisplay Camera Advanced setting camera setupMain Setup CAM Title White BAL Focus BacklightMotion DET Auto END Zoom POS InitLens Init Exposure Brightness Reset User PresetUart Mode RET PKT Enable Special Scan GROUP1 Speed TiltLevel GROUP2 Tour Scan GROUP1Patrol Preview PatternRecord Delete Control Privacy Mask MASK1~4 Initialize Operation with EKB 500 Keyboard General key description EKB 500 Operation with Everfocus Protocol EVF-2 Operation outline Eptz 100 setup menu Preset positionsAutopan Switch Alarm Out 1-8 on Switch Alarm Out 1-8 OFF Preset toursRemote switching of Eptz 100 output relay Pattern tours EKB 500 Operation with PELCO-D/P Protocol Group 1 Tour ALL Preset TourPatrol Tour Group 2 Tour Switch relay on F4 1 Enter Switch relay OFF CLR + F4 1 Enter Switch Alarm Out Appendix a Basic Settings AT EKB 500 Keyboard COM Port Setting RS-485 Interface SettingDevice Setting Camera Ecor / Paragon Series Appendix B Basic Settings AT Everfocus DVREDR / Edvr / Edsr Series Except EDSR100, EDSR100H System I/O Control menu Recovering Communication Settings of Camera Module General Malfunction Head Office USA Subsidiary European Subsidiary China Subsidiary Japan Subsidiary