EXP Computer S200 manual Routing, Supported, Dual Ethernet LAN, Cmem

Dual LAN Ethernet

Routing	In IP/IPX or AppleTalk routing environments, do not connect both Ethernet LAN
	ports to the same Ethernet segment with identical routing decision values. This is not
	supported.

How to Configure Follow these steps to configure a node for Multiple Ethernet LAN.

Dual Ethernet LAN

Step		Action	Result/Description
1	Make a local CTP connection to a		The CTP is physically connected to
	PathBuilder S24x, 26x, and 27x		the device you are configuring.
	switch.
2	Select Configure -> Port from the		The Port record appears.
	CTP Main menu.
3	Configure the Port record as you		Two new parameters, Bridge Link
	normally do for an Ethernet LAN		Number and Router Interface,
	connection.		appear in the record.
4	At the Bridge Link Number:		This matches this port configuration
	parameter, type in a number 1-4to		to a specific bridge link number
	identify the bridge link, and press		within the bridging configuration. If
	Return.		the bridge link you select is already
		Note	used, a warning message appears,
			but your input is retained in the
	The default value for this
			CMEM.
	parameter is 1.
5	At the Router Interface Number:		This matches this port configuration
	parameter, type in a number 1-4 to		to a router link number within the
	identity the router interface.		router configuration. If the router
		Note	interface number you select is
			already used, a warning message
	The default value for this
			appears, but your input is retained
	parameter is 1.
			in the CMEM.
6	Type; and press Return to save the		This saves the record.
	record.
7	Perform a Node boot from the Boot		This implements your changes, but
	menu.		if you want the new bridge link to
			be active, you must configure the
			Bridge Link record under the
			Configure Bridge menu. Go to the
			following step. By default, the
			bridge link is not activated until you
			activate it.
8	Select Configure Bridge ->		The Bridge Link Parameters menu
	Bridge Link Parameters from		appears.
	the CTP Main menu, to activate the
	bridge link.
9	Type ; and press Return.		The record is saved.

118 Bridging