Bridge Filtering

MAC Address Filtering

What Is It?This feature lets you filter bridge traffic based on MAC address.

The Bridge Link Table and the MAC Address Filter Table are used to configure

MAC Address filtering.

The Bridge Link Table specifies:

Whether or not any filtering action is to be performed.

The filtering action to perform when the MAC frame address is not found in the MAC Address Filter Table.

The Bridge Link Table contains these parameters, including the MAC Address Filtering Action parameter, which lets you specify the filtering actions to be applied at the bridge link. These parameters are located under the Configure Bridge Link menu selection:

Entry Number

Bridge ID

Hop Count Limit

Largest Frame Size

MAC Address Filter Action

Protocol Filter Action

STPE Link State

STPE Priority

STPE Path Cost

MAC Address Filter Table Parameters

The MAC Address Filter Table specifies:

The MAC Address of the frame to be filtered.

The filtering action to perform on the frame.

This table is used in conjunction with the Bridge Link Table to specify filtering action and includes the link action parameters which allow you to apply filtering action to every link.

This table describes the MAC Address Filter Table parameters.

Parameter

Action

 

 

MAC Address

Frames that have MAC Addresses matching this MAC

 

Address are filtered as specified by the parameters in this

 

table.

 

 

Incoming Source

Perform filtering action on an inbound frame having the

Address Link Action

indicated MAC Source address.

 

 

Outgoing Source

Perform filtering action on an outbound frame having the

Address Link Action

indicated MAC Source address.

 

 

Incoming

Perform filtering action on an inbound frame for the

Destination Address

indicated MAC Destination address.

Link Action

 

 

 

58

Bridging

Page 62
Image 62
EXP Computer S200 manual MAC Address Filtering, Parameter Action